InteliNano
NT
MRS 3 Operator Guide,
©ComAp – July 2017
2
1
Operator Interface
6
2
7
8
3
1
5
4
9
Figure 1.1
GEN-SET CONTROL BUTTONS
Position
Button
Description
1
Start (
START
) button. Works in Manual mode only. Press this button to
initiate the start sequence of the engine - in Manual operating mode only.
This button is also used to confirm changes in setup mode.
2
Auto (
AUTO
) button is dedicated for switching between auto and manual
operating mode.
3
Stop (
STOP
) button. Press this button to initiate the stop sequence of the
gen-set when engine is running - in Manual operating mode only. This button
is also used to cancel changes in setup mode, to go back or to exit and for
alarm confirmation.
4
Up (
▲
) button for move up or value increasing.
5
Down (
▼
) button for move down or value decreasing.
