ComAp InteliLite AMF25, Глобальное руководство

Страница: 117 / 735

InteliLite Global Guide
117
Image 5.29 Principle of analog switch
5.5.16 Additional running engine indications
It is helpful to have information other than speed (RPM), whether the engine is rotating or not, especially if RPM
is measured from the generator frequency instead of magnetic pickup. The generator frequency measurement
can be unreliable at very low speeds and/or may have a delayed reaction to sudden and big changes (i.e. in the
moment that the engine has just started…).
The following conditions are evaluated as additional running engine indication:
Voltage on the D+ input is higher than the D+ Treshold (page 206) of battery voltage. Connect this input to
the D+ (L) terminal of the charging alternator and enable the D+ function by the setpoint D+ Function (page
204) . If D+ terminal is not available, leave the input unconnected and disable the function.
The pickup is not used and frequency is not detected on the pickup input. Connect the pickup input to the W
terminal of the charging alternator if you do not use pickup and the W terminal is available. If not, leave the
input unconnected.
Oil pressure > Starting Oil Pressure (page 192) setpoint. The oil pressure is evaluated from the analog
input or from the ECU if an ECU is configured.
Binary input O
IL
P
RESSURE
(
PAGE
534) is in logical 0.
At least one phase of generator voltage is >25% of nominal voltage.
These signals are used during start for powering down the starter motor even if still no RPM is measured and
also during stop in order to evaluate if the engine is really stopped.
5.5.17 Voltage phase sequence detection
Controller detects phase sequence voltage terminals. This protection is important after controller installation to
avoid wrong voltage phase connection. There is fix defined phase sequence in controller L1, L2, L3. When the
phases are connected in different order (e.g. L1,L3,L2 or L2,L1,L3) following alarms are detected:
Generator CCW Rotation (page 668)