ComAp Inteli Mains NT BaseBox, Руководство по связи

Страница: 77 / 152

IGS-NT Communication Guide
77
6 Connection
6.1 Recommended CAN/RS485 connection 77
6 back to Table of contents
6.1 Recommended CAN/RS485 connection
6.1.1 CAN bus connection
The bus has to be terminated by 120 Ohm resistors at both ends.
The bus has to be terminated by 120 Ohm resistors at both ends. External units can be connected on the CAN
bus line in any order, but keeping line arrangement (no tails, no star) is necessary.
Standard maximum bus length is 200m for 32C CAN BUS MODE and 900m for 8C CAN BUS MODE (setpoint
in comms setings group).
Shielded cable has to be used, shielding has to be connected to PE on one side (controller side). Recommended
data cables: BELDEN ( www.belden.com )
For shorter distances (up to 50 m): 3105A Paired - EIA Industrial RS-485 PLTC/CM (1x2 conductors)
For longer distances: 3106A Paired - EIA Industrial RS-485 PLTC/CM (1x2+1 conductors)
In case of surge hazard: 3106A Paired - EIA Industrial RS-485 PLTC/CM (1x2+1 conductors)