ComAp IG-NT GC, Справочное руководство

Страница: 66 / 260

IGS-NT-BC, SW Version 1.2.0,
©ComAp – January 2019
IGS-NT-BC-1.2.0 Reference Guide.PDF
66
•
BASEPF: The gen-set power factor is controlled to a preadjusted level
#SysPwrFactor .
•
VSHARING: The power factor is equalized with other gen-sets according
to the actual reactive load.
N
OTE
:
If the power factor control mode is switched to VSHARING the load control mode
must be switched to LDSHARING.
Setpoint: SysBaseLdMode
Group Process control
Range [units] INTERNAL, EXTERNAL [-]
Related FW 3.0
Force value
possible YES
Description This setpoint selects from where the System Base load value is taken if the load
control mode in parallel-to-mains operation is switched to baseload (i.e.
#SysLdCtrl PtM = BASELOAD).
INTERNAL The baseload is adjusted by the setpoint #SysBaseLoad .
EXTERNAL The baseload is adjusted by the logical (functional) analog
input
MLC:AnExSysBld .
N
OTE
:
If the external source is selected the logical analog input must be configured at
each gen-set to the identical source. The
shared peripherial modules can be used
to distribute the value over the controllers via the CAN2 bus.
•
One controller measures the value physically on it's analog input and the
function
MLC:AnExSysBld is configured onto this physical input. But the
value is also beeing transmitted from this controller to the CAN bus via
one shared analog output (e.g. SHAOUT #1.1).
•
The other controllers reads the value from their shared analog inputs (e.g.
SHAIN #1.1) and the function
MLC:AnExSysBld is configured onto these
shared inputs.
•
The transmitting controller must be always switched on!
Setpoint: SysBasePFMode
Group Process control
Range [units] INTERNAL, EXTERNAL [-]
Related FW 3.0
Force value
possible YES
Description This setpoint selects from where the System Power Factor value is taken if the PF