InteliDrive Lite - 1.2.1 Global guide
10
2 System overview
2.3 Configurability and monitoring
2.1 Warnings
InteliDrive Lite controller can be remotely controlled. In case of the work on the engine check, that nobody can
remotely start the engine.
To be sure:
Disconnect remote control via RS232 line,
Disconnect input REM START/STOP or
Disconnect output STARTER
Note:
Because of large variety of InteliDrive Lite parameters setting, it is not possible to describe all
combination. Some of InteliDrive Lite functions are subject of changes depend on SW version.
Note:
The data in this manual only describes the product and are not warranty of performance or characteristic.
Note:
SW and HW must be compatible (e.g. ID-FLX-Lite firmware and ID-FLX-Lite hardware) otherwise the
function will be disabled. If wrong software is uploaded the message HARDWARE INCOMPATIBLE appears
on the controller screen.
Note:
In the case of using Boot load (jumper) programming – close Boot jumper, follow instruction in LiteEdit
and upload correct software.
2.2 General description
The key feature of InteliDrive Lite is its easy-to-use operation and installation. Predefined configurations for
typical applications are available as well as user-defined configurations for special applications.
InteliDrive Lite is a comprehensive controller for single engines with extended support of electronic engines and
plug-in modules.
InteliDrive Lite controllers are equipped with a powerful graphic display showing icons, symbols and bar-graphs
for intuitive operation, which sets, together with high functionality, new standards in engine controls.
InteliDrive Lite provides gas engine support without ventilation.
Controller supports WebSupervisor system. This system enables engine fleet and assets management as well
as pure monitoring. Visit
and
for more details about
WebSupervisor
The key features are:
ECU support - for singlespeed and allspeed engines e.g. Cummins, Volvo, JohnDeer etc.
Flexibility - with our extension modules e.g. IL-NT-AIO, IL-NT-BIO8 etc.
