16
DAILY MAINTENANCE
SOLUTION FILTER CLEANING
1. Loosen the solution tank cap
2. Remove the filter by pulling the cover upward, clean it thoroughly
3. Reassemble everything by pushing until the cover of the filter casing snaps
closed
CLEANING THE SQUEEGEE
Check the squeegee is always clean, for better drying results.
To clean it you must:
1. remove the tube from the squeegee
2. loosen the knobs (1) shown in the figure
3. remove the nozzle and clean it
4. carefully clean the inside of the squeegee
5. carefully clean the squeegee rubbers
6. reassemble all the elements.
DISASSEMBLING THE BRUSH
This machine is fitted with an automatic brush release system to facilitate the
operator's work. Proceed as follows:
1. Raise the base by means of the lever (1)
2. Apply the brake to the machine, using the lever (2)
1
2
3. Turn on the brush switch (6); pulse push the man present lever (2) and
release it.
The brush will start up for a while and then fall under the casing.
ATTENTION!
During this operation, check there are no
people or objects near the brush.
6
5
4
2
