Page 6 of 16
INSTRUCTION MANUAL
LI-150C
LINE IMPEDANCE STABILIZATION NETWORK
19121 El T oro R d ● S il vera d o, Ca lifo rnia 926 76 ● (94 9) 459 - 9600 ● com - p ower.com
REV021317
3.2 Incoming Inspection
To avoid possibility of electrical shock, do not apply power to the LISN if there is
any evidence of shipping damage. If shipping damage to the product or any of
the accessories is suspected, or if the package contents are not complete,
contact Com-Power or your Com-Power distributor.
Please check the contents of the shipment against the package inventory in
section 3.3 to ensure that you have received all applicable items.
3.3 Package Inventory
Equipment, accessories, and documents supplied with the model LI-150C LISN are
as follows:
Calibration data and Certificate traceable to NIST.
Superior Electric shrouded plugs for EUT and power connection.
Optional items
ISO-17025 calibration data and certificate.
External transient limiter model LIT-153.
3.4 General Safety Instructions
The following safety instructions have been included in compliance with safety
standard regulations. Please read them carefully.
•
READ AND RETAIN INSTRUCTIONS
- Read all safety and operating
instructions before operating the instrument. Retain all instructions for
future reference.
•
HEED WARNINGS
- Adhere to all warnings on the instrument and
operating instructions.
•
FOLLOW INSTRUCTIONS
- Follow all operating and use instructions.
•
WATER AND MOISTURE
- Do not use the instrument near water.
•
VENTILATION
- The instrument should be used/installed only in locations
where the flow of air through the ventilation openings is not impeded.
•
MOUNTING –
The instrument can be used in Horizontal or vertical
orientation as long as the ventilation holes are not obstructed and the
protective grounding is not defeated.
•
HEAT
- The instrument should be situated away from heat sources such as
heat registers or other instruments which produce heat.
