Columbus Instruments 0184-006M, Руководство пользователя

Страница: 29 / 39

27
5.6 Controlling the Treadmill via Front Panel
If a PC is not available for treadmill control or if manual control is desired, the front panel
display can be utilized.
5.6.0 Odometer Reset
The odometer will always measure the distance traveled by the treadmill belt in all modes of
operation. When the experiment has begun, typically, the odometer is reset to record the
distance the subjects have run. Press
the black round button in the lower left
corner of the Treadmill Controller to
reset the odometer (F ‐ 47). The
odometer will begin to count when the
button is released. Alternatively, you
may press the Clear Dt button within
the Treadmill Software Diagnostics
window.
5.6.1 Run
By setting the “TREADMILL BELT” toggle
switch to “RUN” the result will be an
adjusted speed correlating to the value
set by the “SPEED” knob (F ‐ 48).
The display will report the speed value
set by the “SPEED” knob and the mode
indicator will be a progress bar that
grows from left to right.
5.6.2 Accel
When the “TREADMILL BELT” toggle
switch is set to “ACCEL”, then the
treadmill belt speed will increase from
the speed set by the “SPEED” knob up
to the “MAX SPEED” setting at a
ramping rate calculated from the
acceleration parameters in 0.1m/min
steps (F ‐ 49). The display will report the
current speed of the treadmill belt and
the mode indicator will be a staircase
Figure 47
Figure 48
Figure 49