S
ECTION
6 — M
AINTENANCE
& A
DJUSTMENTS
23
6.
Engage the PTO.
7.
Remain in the operator’s position with the cutting deck
engaged for a minimum of two minutes, allowing the
underside of the cutting deck to thoroughly rinse.
8.
Disengage the PTO.
9.
Turn the ignition key to the STOP
position to turn the
tractor’s engine off.
10.
Turn the water off and detach the hose coupler from the
water port on your deck’s surface.
11.
After cleaning your deck, return to the operator’s position
and engage the PTO. Keep the cutting deck running for a
minimum of two minutes, allowing the underside of the
cutting deck to thoroughly dry.
Tires
Check the tire air pressure after every 50 hours of operation or
weekly. Keep the tires inflated to the recommended pressures.
Improper inflation will shorten the tire service life. See the tire side
wall for proper inflation pressures. Observe the following guidelines:
WARNING!
Never exceed the maximum inflation
pressure shown on the sidewall of the tire.
Do not reinflate a tire that has been run flat or seriously under inflated.
Have it inspected and serviced by a qualified tire mechanic.
General Battery Information
WARNING!
t
Should battery acid accidentally splatter into the eyes or
onto the skin, rinse the affected area immediately with
clean cold water. If there is any further discomfort, seek
prompt medical attention.
t
If acid spills on clothing, first dilute it with clean water, then
neutralize with a solution of ammonia/water or baking
soda/water.
t
NEVER connect (or disconnect) battery charger clips to
the battery while the charger is turned on, as it can cause
sparks.
t
Keep all sources of ignition (cigarettes, matches, lighters)
away from the battery. The gas generated during charging
can be combustible.
t
As a further precaution, only charge the battery in a well
ventilated area.
t
Always shield eyes and protect skin and clothing when
working near batteries.
t
Batteries contain sulfuric acid and may emit explosive
gases. Use extreme caution when handling batteries. Keep
batteries out of the reach of children.
Battery Maintenance
t
The battery is filled with battery acid and then sealed at
the factory. However, even a “maintenance free” battery
requires some maintenance to ensure its proper life cycle.
t
Spray the terminals and exposed wire with a battery
terminal sealer, or coat the terminals with a thin coat of
grease or petroleum jelly, to protect against corrosion.
t
Always keep the battery cables and terminals clean and
free of corrosion.
t
Avoid tipping. Even a sealed battery will leak electrolyte
when tipped.
WARNING!
Batteries contain sulfuric acid and may
emit explosive gases. Use extreme caution when
handling batteries. Keep batteries out of the reach
of children.
Battery Storage
1.
When storing the tractor for extended periods, disconnect
the negative battery cable. It is not necessary to remove
the battery.
2.
All batteries discharge during storage. Keep the exterior
of the battery clean, especially the top. A dirty battery will
discharge more rapidly.
3.
The battery must be stored with a full charge. A discharged
battery can freeze sooner than a charged battery. A fully
charged battery will store longer in cold temperatures than hot.
4.
Recharge the battery before returning to service. Although
the tractor may start, the engine charging system may not
fully recharge the battery.
Using the Transmission Bypass Rods
If for any reason the tractor will not drive or you wish to move the
tractor, the two hydrostatic transmissions are equipped with a bypass
rod that will allow you to manually move the tractor short distances.
WARNING!
Do not tow the tractor, even with the
bypass rod engaged. Serious transmission damage
will result from doing so.
1.
From the rear of the tractor, just inside the two rear tires,
locate the transmission bypass rods. Refer to Figure 6-2.
a
b
Figure 6-2
Содержание RZT L Series
Страница 42: ...Notes 42 ...
