Columbia CSFH IV 4 Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 5 / 28

5
• Where required by the authority having jurisdiction,
the installation must conform to the American Society
of Mechanical Engineers Safety Code for Controls and
Safety Devices for Automatically Fired Boilers, ANSI/
ASME No. CSD-1.
• LOCATE BOILERS in front of fi nal position before
removing crate. Provide a level solid base as near the
chimney as possible, and centrally located with respect
to the heat distribution system as practical.
• When installed in utility room, door should be wide
enough to allow largest boiler part to enter, or to permit
replacement of another appliance such as water heater.
WARNING
Fire hazard. Do not install boiler on combustible
fl ooring or carpeting. Failure to follow these
instructions could result in death or serious injury.
!
Boiler must not be installed on carpeting or vinyl fl ooring.
Minimum clearances to combustible construction are:
TOP .......................................... 24 IN.
FRONT ...................................... 24 IN.
FLUE CONNECTOR ........................ 9 IN.
REAR .......................................... 6 IN.
SIDES ......................................... 6 IN.
NOTICE
Clearance for access should exceed fi re protection
clearance.
REMOVE CRATE and plastic protective wrapper, inspect for
damage.
Move boiler to permanent position by sliding or walking.
INTRODUCTION
WARNING
Improper installation, adjustment, alteration, service
or maintenance could result in death or serious
injury.
!