COLUMBIA VAC CV12, Руководство пользователя

Страница: 4 / 32

CENTRAL POWER UNIT
The central power unit may be installed in a garage or a
utility room to reduce the noise and the impact on living
areas. The location of the main unit should be a dry, well-
ventilated place.
UWAGA
- The motor does not need lubrication. Bearings are
permanently sealed and lubricated.
- Motor brushes should be checked by the authorized
service after 500 hours of operation.
Clean the central unit with a soft cloth. Note: do not use
liquid cleaners due to the risk of electric shock.
The central power unit is of a suspended type, the
receptacle for dust (dirt) is located on the bottom. The
receptacle can be dismantled and the dirt removed.
We suggest emptying the receptacle every 3-4 months.
To ensure the highest performance it is recommended
to empty the receptacle when it is half full. Our central
power units are adapted for the voltage of 230V~50Hz,
we recommend using sockets higher than 10 AMP with
a single individual circuit. The main power unit is supplied
along with a self-cleaning filter.
During standard operation you do
not need to clean or replace it.
Nevertheless, check the filter once
a month for damage or fractures.
If the filter is damaged by glass
or other sharp objects, replace it
immediately.
Do not use the vacuum cleaner with
a damaged filter. Do not vacuum
any substances that may solidify as
it may clog the filter. If you need to
clean the filter, perform the following
five easy steps:
a) Remove the dirt receptacle.
b) Wrap a large plastic trash bag
around the lower part of the power
unit (as illustrated).
c) Grab the bottom of the filter. Shake
vigorously. Dirt will drop into the bag.
The vacuum cleaner should
be mounted on the wall in the
distance no smaller than:
- 30 cm from the ceiling
- 30 cm from the corner of the wall
- 70 cm from the floor