2007 Eagle Electric Golf Car Service Manual
© December 2007
8-5
Section 8 - Body and Chassis
Figure 8-10. Bag Rack Mounting
Remove nut
and cable
Bag rack
mounting
hardware
One additional washer
at each mounting hole
between rack and
body
Figure 8-11. Tail Light and Turn Signal
Tail light
assembly
Rear turn signal
assembly
BAG RACK
Removing Bag Rack
1. Raise rear body to the full upright position.
2. Remove nut and restraint cable from mounting stud (Figure
8-10).
3. Carefully lay body all the way back. Remove remaining four
bolts washers and nuts. There is also one washer between
bag rack and body at each mounting hole.
4. Hold the rear body in an upright position, and using a rubber
or rawhide mallet, carefully tap the bag rack out towards the
rear and remove it from the rear body.
TAIL LIGHTS AND REAR TURN SIGNALS
Removing Tail Light or Rear Turn Signal
1. Raise rear body to the full upright position.
2. Unplug wiring harness at light or turn signal (Figure 8-11).
3. From inside the body, push the light or turn signal out of the
rubber housing.
4. If rubber housing is damaged or worn, remove it from the
body for replacement.
Installing Tail Light or Rear Turn Signal
1. If rubber housing was removed, install new housing by push-
ing it into the hole, Position the wiring connector notch at the
bottom.
2. Install new light or turn signal into rubber housing, pressing
into the housing from outside the body. Be sure to align wire
connector inlet with notch on rubber housing.
3. Reconnect wiring harness.
Figure 8-9. Middle Body Strap Mounting
Strap mounting
locknut and washer
Find replacement parts for your cart faster at
CartPros.com
