Version 1.00
38
Global Scanning UK Ltd © 2018
Operation
Loading documents into the scanner
Caution: The scanner’s scan glass will be permanently damaged if you try to scan documents
that contain staples, paper clips or other similar objects. Avoid scanning documents with sticky
tape or Post-It notes as the glue can adhere to the scan glass resulting in image quality issues.
To scan thicker documents, such as the calibration target, remove the document return guide(s)
to provide a straight paper path.
The original document will be loaded into the scanner face up in the centre.
If using auto-size, the exact position is not critical.
If using fixed sizes, align to the appropriate mark on the document size strip.
ISO/DIN sizes are shown above the line
ANSI sizes are shown below the line to the left only.
ARCH sizes are shown below the line to the right only.
Aligning a document can be made easier by fitting either 1 or 2 Paper Edge Guides.
Using two hands, hold the document at both sides near the lead edge, giving a little outward
tension to make the lead edge of the document straight. Present the lead edge to the scanner
keeping the lead edge square to the feed rollers. After a delay of approximately 0.5 seconds, the
feed rollers will automatically take the document into the scanner and place it in the correct
position ready for the Scan or Copy operation.
The scanner displays the detected paper size. Tolerance is set to +/-1.25%. "Custom Size" is
displayed for all other widths.
