Four 12-watt R/G/B/A/W/UV 6 in 1 LEDs.
3,6,8, 10 or 11-channel DMX modes.
Built-in 5200 mAH lithium battery,The battery is very easy to replace.
Built-in DMX512 wireless receiver/transmitter,adopt 2.4G ISM frequency section( global opening
section) without permission limited. High effective GFSK modulate,communication design ; 126
channels jumping frequency
automatically，
high anti-jamming ability.
FEATURES
Page 4
Page 9
General dimming 0-100%
11CH Mode
CHANNEL
1
2
3
4
5
8
9
10
11
VALUE
000-255
Green dimming 0-100%
Red dimming 0-100%
Blue dimming 0-100%
Amber dimming 0-100%
Dimming
Not used
Dark - bright
Bright - dark
Dark -bright - dark
Dark -bright - dark (auto run)
Color flash change
Sound activated
Speed adjustment
Uses the “nodE” setting
DIMMING 0
DIMMING 1
DIMMING 2
DIMMING 3
DIMMING 4
Slow - fast
Fade
Strobe (fast - slow)
000-255
000-255
000-255
000-255
6
White dimming 0-100%
000-255
7
UV dimming 0-100%
000-255
000-014
000-031
032-063
064-095
096-127
128-159
160-191
192-223
224-255
000-255
000-005
006-055
056-105
106-155
155-205
205-255
015-255
FUNCTION
PRIORITY
1
2
3
REMARKS
Must use channels
1-6 to get light.
Channel 9 is speed
adjustment.
Similar to the “nodE”
setting, but with
variable speed
control. DIMMER0
has the fastest range,
DIMMER4 the
slowest. Dependent
on use of channels
1-7.
32-bit smooth dimming technology, flicker free for TV and camera shooting.
IR control: Infrared remote control up to 30 ft./ 10M .
Variable electronic strobe, dimming and color changing effect.
Stand-alone, Master/Slave and DMX modes.
Daisy chain connections to connect additional units.
DIMENSIONS
SAMPLE WIRING DIAGRAM
DMX TERMINATION
The following diagram shows a sample wiring chain using multiple lights. Note that as with all
DMX chains, the last unit must have a DMX terminator connected to the DMX output.
As with all DMX devices, the last unit in any chain must have a DMX terminator
connected to the DMX output. If using just a single light,connect a DMX terminator
to the DMX output.
A DMX terminator is a DMX plug with a 120-ohm, 1/4-watt resistor soldered
between pins 2 and 3.
AC100V-260V
Power Out
DMX 512 Controller
DMX Out
TO Terminator
M10
25
°
