8
Operation and Control
Fine tuning your Mover Wash Hex 12 start position
The Mover Wash HEX 12 offers the ability to adjust your starting position should your
lights begin to vary after use due to bumps received during transit or use
•
To enter adjustment program, press Menu and hold Enter key for 3 seconds
•
Use Up and Down navigation arrows to select Pan or Tilt, pressing enter to make
your selection.
•
You may now enter fine adjustments from -127 to 127 for both Pan and Tilt to start
your light in its desired position.
•
Press Enter to confirm your selection and Menu to exit adjustments program.
•
Your Mover Wash will now start at desired position going forward.
Controlling your Mover Wash HEX 12 using a DMX controller:
•
Use a DMX cable to connect your Mover Wash HEX 12 to the DMX in/out sockets
on the bottom of the light.
•
Set desired DMX address for your light
Using Master/Slave Mode:
The Master/Slave mode allows a group of Mover Wash HEX 12 units (the slaves) to
duplicate the output of another Mover Wash HEX 12 (the master) without a DMX
controller.
1. Set each of the slaves:
n
Go to SLNd in the main menu and press enter.
n
Select SL1.
2. Set the master:
n
Go to SLNd in the main menu and press enter.
n
Select NASt.
•
The master (NASt) is the unit that runs your program whether in one of the static
color modes or various Auto programs.
