Plug Into
Power Driver
Board
J-138
(B.B.)
Optional
:
Only use the male-to-male
adapter to reconnect a
pre-existing cable back
into J-138
Plug Into
ColorDMD
PWR
J-604
J-603
A/V Board
Power Driver Board
Route the new ColorDMD
Power Cable along with
the existing cables for a
clean install.
Figure E
J-138
Locate the included 4-pin ColorDMD power cable. One end of the
cable has a single connector (see Fig. D). Plug this connector
into the PWR header (see Fig. C) on the ColorDMD.
ALL RIGHTS RESERVED - PATENT PENDING - COPYRIGHT 2012 - COLORDMD DISPLAYS LLC
Plug the other end of the new ColorDMD Power Cable (see Fig. D)
into J-138 on the WPC95 Power Driver Board (see Fig. E). If an
existing cable is currently plugged into J-138, disconnect it before
connecting the ColorDMD power cable
.
If you disconnected a cable from J-138 in the previous step, use
the included male-to-male adapter to re-connect this cable to the
available center connector on the ColorDMD cable (see Fig. D).
Otherwise, do not connect the male-to-male adapter and store it
in a safe place.
The disconnected cable may alternatively be connected to the
AUX header on the ColorDMD board (see Fig. C).
7
8
Figure D
9
STEP
STEP
STEP
NOTE
TIP
