8-Pin DMD Power Cable
(
Remove entire cable
from the game
)
14-Pin DMD Ribbon Cable
(Unplug cable from DMD
and leave other end
connected to game)
Figure A
Carefully remove the translite from the backbox and then lower
the speaker panel to the position shown in Fig. A to gain access
to the backbox.
ALL RIGHTS RESERVED - PATENT PENDING - COPYRIGHT 2012 - COLORDMD DISPLAYS LLC
WPC95
Installation
Instructions
Be sure to turn
OFF
the power to the pinball machine before
installing the ColorDMD display.
Tools Required
: Phillips screwdriver
Remove and save all four DMD mounting screws. Remove the
original DMD from the game and store it in a safe place.
1
2
3
STEP
STEP
STEP
!
Disconnect the DMD power and ribbon cables from the DMD.
Unplug the DMD power cable from the high-voltage A/V board
J-604 (see Fig. E), and
remove this cable from the backbox
.
Congratutions on the purchase of a new ColorDMD display. The ColorDMD
will enhance your pinball machine by introducing
color
to the dot matrix
display graphics produced by the game.
•
