OPERATION
www.colorbeam.com
9
★
Standby Mode
(2)
Fade Effect: There are 6
built
-
in
fade effects.
Press UP and DOWN to select
the desired effect
from
F01
~
F06
.
Note:
The fade time of program can be changed from 01~99%
(
0
.
5
~
50sec
)
to set the
fade
time
press
the
enter
button.
The display
shows
“
Decay ratio
”
,
the fade time can be adjust from 01~99% by pressing
UP
and DOWN. To
confirm and activate time setting press enter again, or press exit to the next
program.
Remark:
To have the output saved and work the same output when turn on the
PO-200 again, please press ENTER under the list of each C01~C15, F01~F06
and you will see
“
Status Saved
”
twinkling
.
The
memory
will
stay
on
the
latest
save
only
.
Please note the priority of directives should be DMX signal
→
Demo Mode.
(3)
Self Test:
Press
ENTER
to
test
one
color
on
all
lighting
fixtures
.
Press
ENTER again
to
test
the
next
color
and
so
on
.
(4)
Reset to Initial:
Press
ENTER
twice
.
The
controller
will
return
to
the
original setting
.
First Layer
1. DMX Address
SELECT LIST
Second Layer
Third Layer
001~512
2. Group Mode
Independent
Synchronize
Odd & Even
Duet
3. Timer Mode
Fixed Color / Fade Color
On Time
Off Time
Turn On / Off
C01~C10
F01~F06
4. Master Mode
ON/OFF
5. Demo Mode
Fixed Color
Fade Color
Self Test
Reset to Initial
C01~C10
F01~F06
The control unit will
automatically into Standby mode
in
the
event or
not receiving
any instruction after 2
minutes
.
Under
Standby
mode
,
the
control
unit
is
functional but
display
is
off
and
keypad
is
locked
.
To
leave
Standby
mode
,
press
and
hold ENTER
button
for
3
seconds
till
display is on.
When using
DMX Address control the fixture, the Standby mode will start after 2
minutes.
Press and hold Menu. button for 3 second to leave Standby
mode.
