2
Pace Clock Operation
Standalone Pace
Clock
For simple pace clock operation, turn the Pro Pace Clock on. Set the
Scoreboard/Training switch to Training, and set the Mode switch to
2. The pace clock will display 02 (for mode 2), and then reset itself
to :00 and begin counting up. After displaying 59:59, the display
rolls over to :00.
Pace Clocks in
Series
Without Timer or
Controller
To run a series of pace clocks without an external controller, set the
Scoreboard/Training switch on the front panel of the first pace clock
to Training, and set the Mode switch to 2. Set the other pace clock(s)
to Scoreboard and Mode 1. Connect the pace clocks with data cables
using the round 4-pin (RS-485) connectors. All connected pace
clocks will display the same information.
Turn the pace clocks on with the power switch on the front panel.
The pace clocks will begin counting up from zero, displaying time as
minutes and seconds. After displaying 59:59, the displays will roll
over to :00.
With Timer or
Controller
A clock or series of clocks can be controlled using a CTS timer or
pace clock controller. The clock(s) will display information from the
timer or pace clock controller based on the setting of the Mode dial.
See Chapter 3 starting on page 7 for specifics about Water Polo, and
Chapter 5 starting on page 19 for specifics on other sports.
Pace Clock Operation
5
Содержание Pro Pace Clock
Страница 1: ...User Guide Pro Pace Clock and Shot Clock F891 Rev 1106...
Страница 10: ...Pace Clock Operation 6...
Страница 22: ...Training Modes 18...
Страница 27: ......
