（
Picture 6
）
Sound
Sound
Sound
Sound Operation
Operation
Operation
Operation
Press the MENU button until it shows one of the following
：
- SOUF: Sound-active effect
（
mode 1
）
- SOUD: Sound-active effect
（
mode 2
）
Press UP or DOWN button to select.
Press Enter button to save or press MENU button to exit.
Manual
Manual
Manual
Manual Operation
Operation
Operation
Operation
Press the MENU button until it shows C1-C4 in the display. C1-C4 means Red,
Green, Blue respectively.
Press UP or DOWN button to select C1, C2, C3 or C4. Press the ENTER button, the
last two digits in the display will show 00-12. This is the level of the manual dimmer.
Press ENTER button to save or press MENU button to exit.
4.
4.
4.
4. Mounting
Mounting
Mounting
Mounting and
and
and
and Installation
Installation
Installation
Installation
-Please keep the fixture away from inflammable materials at least 0.5 meters.
WARNING: Use the hooks to fix at the handle of the fixture. and make sure the place
where you install the fixture is in safe conditions; and make sure it can stand ten
times weight as the fixture. Then test it for at least one hour to see whether it is fine.
-You'd better add second protection to avoid the lose of the spare parts.
Please fix the fixture with the safety chain during installation which has to bear at
least the weight ten times as the light.
5.
5.
5.
5. DMX-512
DMX-512
DMX-512
DMX-512 control
control
control
control connections
connections
connections
connections
Connect the provided XLR cable to the female 3-pin XLR output of your controller
and the other side to the male 3-pin XLR input of the moving head. You can chain
multiple wall washers together through serial linking. The cable needed should be
two core, screened cable with XLR input and output connectors. Please refer to the
diagram below.
Building
Building
Building
Building A
A
A
A Serial
Serial
Serial
Serial DMX
DMX
DMX
DMX Chain
Chain
Chain
Chain
：
Connect the DMX output of the 1st device in the
DMX chain with the DMX input of the next device. Always connect one output with
the input of the next until all devices are connected.
DMX
DMX
DMX
DMX Start
Start
Start
Start Address
Address
Address
Address Setting
Setting
Setting
Setting
This device has 8 DMX channels. If you set, for example, the start address to
channel 1, the device will use the channels # 1st to 8th for control. The first available
channel for the next fixture will be the 9th.
Please be sure that you do not have any overlapping channels in order to control
each device correctly and independently from any other fixture on the DMX chain. If
