·
The
is for wash effect for on-site decoration purpose.
·
Don’t turn on the fixture if it’s been through severe temperature difference like
after transportation because it might damage the light due to the environment
changes. So make sure to operate the fixture until it is in normal temperature.
·
This light should be keep away from strong shaking during any transportation or
movement.
·
Don’t pull up the light by only the head, or it might cause damages to the
mechanical parts.
·
Don’t expose the fixture in overheat, moisture or environment with too much dust
when installing it. And don’t lay any power cables on the floor. Or it might cause
electronic shock to the people.
·
Make sure the installation place is in good safety condition before installing the
fixture.
·
Make sure to put the safety chain and check whether the screws are screwed
properly when installing the fixture.
·
Make sure the lens are in good condition. It’s recommended to replace the units if
there are any damages or severe scratch.
·
Make sure the fixture is operated by qualified personnel who knows the fixture
before using.
·
Keep the original packages if any second shipment is needed.
·
Don’t tr y to change the fixtures without any instruction by the manufacturer or
the appointed repairing agencies.
·
It is not in warranty range if there are any malfunctions from not following the
user manual to operate or any illegal operation, like shock short circuit, electronic
shock , lamp broke, etc.
DOTZOOM 60F
.05.
OPERATION INSTRUCTIONS
5
Cautions:
For added protection mount the fixtures in areas outside walking paths,
seating areas, or in areas were the fixture might be reached by unauthorized
personnel.
Before mounting the fixture to any surface, make sure that the installation area can
hold a minimum point load of 10 times the device’s weight.
Fixture installation must always be secured with a secondar y safety attachment, such
as an appropriate safety cable.
Never stand directly below the device when mounting, removing, or ser vicing the
fixture.
INSTALLATIONS
6
.06.
Always use and install the supplied safety cable as a safety measure to prevent
accidental damage and/or injur y in the event the clamp fails.
Mounting points:
Overhead mounting requires extensive experience, including
amongst others calculating working load limits, a fine knowledge of the installation
material being used, and periodic safety inspection of all installation material and the
fixture. If you lack these qualifications, do not attempt the installation yourself.
Improper installation can result in bodily injur y.
Be sure to complete all rigging and installation procedures before connecting the
main power cord to the appropriate wall outlet.
Clamp Mounting:
The
provides a unique mounting bracket assembly
that integrates the bottom of the base, and the safety cable rigging point in one unit
(see the illustration below). When mounting this fixture to truss be sure to secure an
appropriately rated clamp to the included omega bracket using a M10 screw fitted
through the center hole of the “omega bracket”. As an added safety measure be sure
to attached at least one properly rated safety cable to the fixture using on of the
safety cable rigging point integrated in the base assembly.
DOTZOOM 60F
Regardless of the rigging option you choose for your
, always be sure
to secure your fixture with a safety cable. The fixture provides a built-in rigging point
for a safety cable on the hanging bracket as illustrated above. Be sure to only use the
designated rigging point for the safety cable and never secure a safety cable to a
carr ying handle.
DOTZOOM 60F
②
①
Omega
Bracket
②
Satety
Clamp
③
Safety
Cable
④
1
/
4
Turn
Quick
-
Lock
Fasteners
①
③
④
1/4 Turn
1/4 Turn
