10.
10.
10.
10. Specifications
Specifications
Specifications
Specifications
Input Voltage: AC90-260V 50/60Hz
LED Quantities: 12PCS CREE XLamp MC-E 10W 4-IN-1 LEDs (R, G, B, W)
Control Signal: DMX512, master-slave and sound activated or auto operation
Control Channel: 15 DMX channels
Power Consumption: 140W
Dimensions: 152(D)*265(W)*310(H)mm
Packing Dimensions:260(D)*320(W)*335(H)mm
Net Weight: 4.9kg
Gross Weight: 7kg
2.
2.
2.
2. S
S
S
Safety
afety
afety
afety IIIInstructions
nstructions
nstructions
nstructions
This device has left the factory in perfect condition. In order to maintain this condition and to ensure a
safe operation, it is absolutely necessary for the user to follow the safety instructions and warning
notes written in this user manual.
If the device has been exposed to temperature changes due to environmental changes, do not switch
it on immediately. The arising condensation could damage the device. Leave the device switched off
until it has reached room temperature.
This device falls under protection-class I. Therefore it is essential that the device be earthed.
The electric connection must carry out by qualified person.
The device shall only be used with rate voltage and frequency.
Make sure that the available voltage is not higher than stated at the end of this manual.
Make sure the power cord is never crimped or damaged by sharp edges. If this would be the case,
replacement of the cable must be done by an authorized dealer.
Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the
power cord by the plug. Never pull out the plug by tugging the power cord.
During initial start-up some smoke or smell may arise. This is a normal process and does not
necessarily mean that the device is defective, it should decrease gradually.
Please don't project the beam onto combustible substances.
Fixtures cannot be installed on combustible substances, keep more than 50cm distance with wall for
smooth air flow, so there should be no shelter for fans and ventilation for heat radiation.
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the
manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
