e-mark create marking device
Chapter 5 Operation
CODI Standard 1.0
38/60
Operating and Maintenance Manual
NOTICE
ALWAYS place the e-mark create in the docking station after use! Otherwise, the ink
cartridge print head dries out.
Recommendation
: ALWAYS place the e-mark create in the docking station first and then switch it off. If the e-mark
create is switched off, NO warning signal sounds, but the e-mark create should always be placed in the docking
station even if switched off.
5.5 Manual cleaning cycle
Wiping:
If printing quality drops and/or excessive ink can be seen on the print head, wiping is required. This cleans the print
head.
Proceed as follows:
1.
Before starting the manual cleaning cycle, place the e-mark create on paper which can be disposed of after
the cleaning cycle.
2.
In the app settings, press "Start quick cleaning" to activate the print head cleaning.
3.
Slide the print head wiper out (wiper, rubber lip) on the underside of the docking station. A lint-free cloth can
also be used, moistened with distilled water.
Fig. 26: Slide out print head wiper
4. Carefully wipe the print head from back to front once with the print head wiper (or with the damp cloth) as
shown in Fig. 27: Clean print head with wiper
Fig. 27: Clean print head with wiper
