Collomix BIAX 45P, Инструкция по эксплуатации

Страница: 12 / 24

BIAX 45P Collomix GmbH
12 Version 1.7-18
6. Operation
Prior to working with the machine, check all parts for their proper condition and function. Do not
start the machine with defective or missing parts.
Check all safety-relevant structural components of the machine for proper function before starting
it. Any defective or damaged parts must be replaced by qualified personnel prior to starting to work
with it.
6.1 Switching on the machine
The machine is turned on using the main switch (3).
After an automatic initialisation, READY is shown on the display.
Any errors detected during initialisation are shown in text form on the display.
6.2 Open the door (starting position)
By pressing button
DOOR
, the door is opening. The display indicates
READY
, the machine is ready
for mixing.
6.3 Load a container
Only use sufficiently stable and tight-closing vessels for mixing. In case of doubt, consult the
manufacturer of the mixing vessels.
To place the container, proceed as follows:

The machine must be in starting position, see 6.2

Observe the weight and size limits of the mixing vessel. Never overload the machine!

Place the container centrically on the mixing table. Place the handle to the rear side against the
rubber band for handle fixation.

If diameter is smaller than 270mm, secure the container handle with a rubber band or an
adhesive.

Use only undamaged containers, never stack containers!
Securing the handle with
a rubber band
Do not stack containers!