Types:
V frequency
Light temperature, K
Power, Watt
Luminous flux, Lum
Length, mm
Parameters:
Fig.1
1. LED illumination lamp AquaLighter 3
Marine
2. Power supply
3. Mou
n
ting
AquaLighter 3 Marine User Manual Guide
Dear Sir and Madam,
W
e thank you for choosing our product. We assure you that you will be
satisfied with the work of this illumination lamp. Please, study this User
Manual Guide before use in order to avoid problems connected to its usage.
Intended Use and Specifications of the Product
AquaLighter 3 Marine LED illumination lamp is designed to
function
over the
water surface and is used for illumination of the marine aquariums. The
movable feet allow you to use the illumination lamp for aquariums of different
length. The source of illumination of the lamp
is
bright LEDs of the latest
generation
produced by
OSRAM (Germany). Unlike fluorescent tube aquarium
lamps, the illumination by AquaLighter 3 Marine creates a dimensional
perception of the aquarium, simulating midday time daylight at the reef.
AquaLighter 3 Marine brings your aquarium to life!
Especially elaborated illumination spectrum of the LEDs lets you successfully
maintain most of the sea plant and animal species. The illumination lamp has
a 3-channel system of illumination sources management and can be
controlled by the external AquaLighter Device controller.
The e
xternal
controller is connected to the illumination lamp
through
a FireWire plug
connector on the butt end part of the illumination lamp.
ATTENTION!
It is strictly forbidden to connect other devices to the controller through
external FireWire plug connectors! Such action will bring these devices and
the controller out of order.
Technical characteristic
Ingress protection rating - IP40
AquaLighter 3
Marine
Illumination Management Channels:
1st Channel - cold-white LEDs (light temperature up to 7500К).
2nd Channel – warm-white LEDs (light temperature up to 3000К) and hyper red
LED with a peak emission at wavelengths of 649-666 nm is used. Such
wavelength coincides with the absorption peak of chlorophyll A, the most
affordable source of energy for the plant growth.
3rd Channel - cold-white LEDs (light temperature up to 7500К).
The illumination lamp can be used for aquariums with
a wall
thickness of up to
12 mm.
Safety Usage Rules
The device you have purchased is manufactured in compliance with the norms
applicable on the territory of Ukraine and
the
European Union. For long lasting
and safe usage, please do study the safety rules listed below:
1. This device is designed to be used only within indoor areas and only
for
its
intended use.
2.
The v
oltage rating of the power supply system has to be exactly the same as
the voltage rating indicated on the device.
3. It is forbidden to
submerge
the device in water! Even a short time
submersion of the device in water can cause damage and can lead to loss of
warranty obligations. If
the device
was accidentally submerged
in water, it
is
strictly forbidden to connect
it
to
the
power supply
!
If such situations arise,
please contact the manufacturer for the repair and further safe usage
of the
device
.
4. It is forbidden to use the device if the device or its electrical cord is damaged.
It is recommended to check the condition of electrical cord each time before
switching it on.
5. Before you switch on the illumination lamp, please make sure it is fixed
safely on the walls of
the
aquarium.
Preparation for Work
Take the protective film
off
the illumination lamp.
Fasten
the feet on the body of
the illumination lamp as shown
in
Fig. 1.
Assembly and Startup
Place the illumination lamp on the aquarium, moving the feet along the body of
the device until you reach the necessary length.
Having fixed
the illumination
lamp safely on the walls of
the
aquarium, plug in the plug of the power supply
cord into the power supply socket situated on the illumination lamp. The device
is ready to use. Connect the power supply block to the power supply system.
Maintenance
The device does not require any special maintenance. If necessary, clean the
body of the illumination lamp from residues resting on it with the help of soft
tissue or a sponge.
* LED lamp AquaLighter 3 90 сm also has special fixing sets with which you can
hang the lamp above the aquarium.
Warranty
The m
anufacturer gives a warranty of 24 months
from
the purchase date.
The warranty covers damages that appeared due to the fault of
the
manufacturer, i.e.
,
material defects
,
etc. The warranty does not cover damages
that appeared due to
the
improper or unintended use of
the
illumination lamp.
Attention! Any trials to change the structure of the device
,
or dismantling of
the device that
,
fall out of the scope of regular intended use or maintenance
lead to loss of warranty obligations.
In case improper functioning of the device is detected
,
please contact technical
support.
The c
ondition for accepting the guarantee is conformity of the date of
sale
to the date of the warranty period specified in the warranty card. The
present warranty conditions do not exclude, limit
,
or cease the rights of the
buyer granted by the applicable legislation of the country where the sale was
made.
www.
aqualighter
.com
YOUR
LED LAMP
FOR AQUARIUM
Aquarium comes alive!
30 cm
60
cm
9
0 cm
22
3
9
1480
2960
280х75х33
120
00
-15000
30
60
90
AC110~230V (50-60Hz) / DC15V/DC24V/DC36V, 2A
5
7
4440
580х75х33
880х75х33
