INSERTING AND REMOVING
THE NOZZLE:
1. Remove the nozzle from the package.
2. Insert the nozzle into the nozzle jack until
it clicks into place.
3. To remove the nozzle, press and hold the
nozzle eject button and gently pull out the
nozzle.
4. To store, place the nozzle in the storage
compartment as shown below.
ADJUSTING THE PRESSURE
SETTINGS:
1. Device turns on in the last mode used.
2. Press the mode button to switch between
pressure settings for your preferred
flossing style:
· Gentle: Low pressure mode
· Regular:
Regular pressure mode for daily
cleaning
·
Pulse:
Pulsation pattern for gum massaging
FILLING THE WATER TANK:
1. Open the water tank cover, then pull
the tank down to the marked line.
2. Lay the flosser flat, face the opening
towards the faucet and fill with either
cold/lukewarm water or mouthwash.
You may use warm water up to 40°C/104F.
3. After filling the tank with water, close the
cover firmly, and dry off any excess liquid.
Nozzle
eject
button
Nozzle storage
compartment
Warning:
Do not eject nozzle during operation.
