Repair
In the event of a leak, patch your pool using the underwater
adhesive repair patch provided.
UnderWater Adhesive Repair Patch (the size of broken ≤ 2.5cm)
NOTE:
Do not need to drain the pool, repair patch can be
used underwater.
3
0’
1. Find the broken area.
3. Carefully peel patch.
4. Apply the repair patch to repaired site and smooth out any
air bubbles. Press for 30 seconds.
2. Clean the area to be repaired.
3
0’
5. Wait 30 minutes before use.
5. Wait 30 minutes before use.
Tritech PVC Material Repair Patch
(2.5cm ≤ the size of broken ≤ 5 cm)
NOTE:
Glue is not included due to shipping constraints.
You can find PVC or silicone-based glue at most retail outlets.
Carefully read the warning labels and closely follow instructions
on the back of glue before attempting the following repair steps.
1. Discharge the water, fully clean and dry area to be repaired.
2. Cut the correct size from the Tritech PVC Material Repair Patch.
3. Apply only the amount of glue (not included) needed to cover
the repair site.
4. Press the repair patch firmly to repair site for 30 seconds.
9
Dismantling
1. Unscrew the drain valve cap on the outside of the pool counter
clockwise and remove.
2. Connect the adaptor to the hose and put the other end of the
hose in the area where you are going to drain your pool.
(Check local regulations for drainage by-laws).
3. Screw control ring of the hose adaptor clockwise onto the
drain valve. The drain valve will be open and water will start to
drain automatically.
ATTENTION:
Water flow can be controlled with
the control ring.
4. When draining is finished, unscrew the control ring to close
the valve.
5. Disconnect the hose.
6. Screw the cap back onto the drain valve.
7. Air dry pool.
ATTENTION:
Do not leave the drained pool
outside.
Storage
1. Please remove all accessories and spare parts of the pool and
be sure they are clean and dry before you store them.
2. Once pool is completely dry, sprinkle with talcum powder to
prevent pool from sticking together. Carefully fold pool.
If pool is not completely dry, mold may result and damage the
pool liner.
3. Store liner and accessories in a dry place with a moderate
temperature between 5ºC / 41ºF and 38ºC / 100ºF.
4. During the rainy season, pool and accessories should be
stored as per above instructions.
5. Improper draining of the pool might cause serious personal
injury and/or damage to personal property.
6. We strongly recommend the pool is disassembled and stored
in a dry location out of chlidren's reach during the off season
(winter months).
IMPORTANT:
When preparing the pool for storage,
make sure there is 10 cm (4 in.) between the folding point and
the circumference of each window. The windows should not be
creased or be folded during storage.
