DANGER
• CARBON MONOXIDE HAZARD
• For outdoor use only.
• Never use inside house, camper, tent, vehicle
or other unventilated or enclosed areas. This
unit consumes air (oxygen). Do not use in
unventilated or enclosed areas to avoid
endangering your life.
DANGER
• EXPLOSION - FIRE HAZARD
• Propane is heavier than air and can
accumulate in low places. If you smell gas,
leave the area immediately.
• Always attach or detach propane source
outdoors; never while unit is lighted, near
flame, pilot lights, other ignition sources or
while unit is hot to touch.
• This unit is very hot during use and can ignite
flammables too close to the burners.
• Minimum distance shall be at least 10 ft (3 m)
from any structure or combustible material.
• Do not use gas fryer on or under any
apartment, or condominium balcony or deck.
• Keep gasoline and other flammable liquids and
vapors well away from unit.
■
Do not attempt to operate until you have read
and understood all General Safety Information in
this manual and all assembly is complete and
leak checks have been performed.
WARNING
• BURN HAZARD
• This appliance will be hot during and after
use. Use insulated oven mitts or gloves for
protection from hot surfaces or splatter
from cooking liquids.
• Never leave fryer unattended when hot or
in use.
• Keep out of reach of children.
10. Observe the flame from below the fryer, looking
between the fryer housing and the grease tray
(Fig. 18).
11. Flame should be blue with a hint of yellow
on tips.
English-8
Operation
Fryer Burner
Lighting
IIN
NS
ST
TA
AS
ST
TA
AR
RT
T™
™ E
Elle
ec
cttrro
on
niic
c
IIg
gn
niittiio
on
n F
Frryye
err::
1. Open the lid.
2. Make sure all valves are OFF.
3. Turn on the cylinder valve.
4. Push in and turn on the Fryer Control Knob
counterclockwise to HIGH. (Fig. 17).
5. Continue to depress and hold the Fryer
Control Knob.
6. Repeatedly press the igniter switch until
the flame ignites.
7. After burner ignition, continue to hold Fryer
Control Knob in for 15-30 seconds.
8. If ignition does not occur in 5 seconds, turn
the Fryer Control Knob off, wait 5 minutes,
and repeat the lighting procedure.
9. If the burner does not light after trying
again, turn off Fryer Control Knob and try
match lighting the burner.
HINT:
If the igniter fails to light the fryer
burner, adjust electrode tip with needle-
nose pliers. A spark must jump near a gas
opening in the burner when igniter is
activated. Use care not to damage the
ceramic insulator on electrode.
Fig. 18
Fig. 17
Depress
and Hold
Push
Repeatedly
