Your 36 Watt Folding Solar Panel must be opened and the blue side must face the sun to begin charging.
PANEL CONNECTION
Connect one panel to another using the quick connects. The single long wire connector on the right panel
“OUT” goes into the small "IN" on the secondary panel. The tester LED will only light when the system is fully
connected. Your two panels are now in parallel.
Installation through the 12 Volt DC plug:
Plug the 12V DC plug into the female socket in vehicle or item. Make sure both ends are secure and aligned
correctly.
Connection to Battery by Alligator Clamps:
Connect the alligator clamps correctly by matching the red clamp which is Positive (+) to the Positive (+)
terminal on the battery. Connect the black Clamp which is Negative (-) to the Negative (-) terminal on the
battery. Follow this carefully to not cause any bodily harm.
Easily connect your solar panel to your power generator with the included barrel connector. Simply insert the
included barrel connecter into the charger input. Once your solar panel is placed in the sun charging will
commence. If using a charge controller, some alteration to the barrel connecter may be required. This will not
void any warranty.
*It is strongly recommended to use a 7 Amp Solar Charge Controller to prevent battery from
overcharging,*
CHARGE CONTROLLER: (If included)
SPECIFICATIONS
Cut-in Voltage:
13 Volts
Cut-out Voltage: 14.2 Volts
Max. Load:
105 watts
