Coleman Powersports 70DX 2020, Руководство пользователя

Страница: 32 / 41

Storage
If the Dirt Bike is left unused for an
extended period of time proper storage
maintenance is required.
1. Wash Dirt Bike thoroughly, then wax
plastics and painted parts with a non
abrasive auto wax. Coat vinyl seat and
rubber parts with a vinyl/rubber protectant.
Note: Keep water away from air intake and
muffler outlet while washing to avoid water
from entering the engine and/or
components.
2. Drain carburetor by turning fuel valve (1)
to the off position and opening the drain
screw (2). Allow all fuel to drain from the
carburetor. Once fuel is drained, re-tighten
drain screw (2).
Note: Make sure to drain fuel in a proper
storage container.
3. Fill fuel tank to full with gasoline mixed
with fuel stabilizer as recommended by the
fuel stabilizer manufacture. Note: Fuel
stabilizer can be purchased at most
motorcycle shops and auto parts stores.
4. Remove spark plug and poor 1
tablespoon of motor oil in the spark plug
hole. Re-install spark plug.
5. Kick the starter lever approximately 5
times with the ON/OFF switch in the OFF
position. This is to coat the inside cylinder
head with oil.
6. Cover the muffler outlet and air intake
with oily rags so the Dirt Bike will be
protected from humidity in storage.
7. Fill tires with correct air pressure.
8. If possible, store Dirt Bike in a shed or
garage with a cover to protect from dust,
dirt and humidity. If the Dirt Bike must be
stored outdoors, cover Dirt Bike completely
with a good waterproof cover.
1
2
Returning to service
1. Wash Dirt Bike thoroughly.
Note: Keep water away from
air intake and muffler outlet
while washing to avoid water
from entering the engine
and/or components.
2. Remove oily rags from air
intake and muffler outlet.
3. Drain engine oil and
replace with fresh clean oil as
listed in this manual.
4. Review this owner’s
manual and follow the pre-
ride inspection procedures.
5. Start engine by following
the starting procedures in this
manual.
STORAGE
29