6
4.2 Installation
Connect the unit to the electricity supply but DO NOT SWITCH ON. Place the unit on a firm, level,
non-slip surface ensuring that there is sufficient free space on all sides without coming into contact
with anything else during use. Switch the unit ON at the mains On/Off switch at the rear of the
instrument. When switched ON, the touch screen display will illuminate and the interface software
will load within 30 seconds.
Do not position the product so that it is difficult to access the ON/OFF switch.
❖
Do not position the product so that it is difficult to disconnect from the mains supply using
the mains plug.
❖
The mains outlet socket used should be located close to the equipment and readily identifiable
and accessible to users.
❖
Allow the instrument to cool before moving.
IF IN DOUBT CONSULT A QUALIFIED ELECTRICIAN
4.3 Warning
High temperatures are dangerous and can cause serious burns to the operator and ignite
combustible materials. Great care has been taken in the design of this product to protect
operators from hazards, but operators should pay attention to the following points:
❖
The sample block will become hot during operation and will remain hot for a period after
operation.
❖
Sample capillary tubes will become hot during operation and will remain hot for a period after
operation.
❖
Wait for the sample block and capillary tubes to cool before entering the sample
compartment and inserting or removing capillary tubes.
❖
Use care and wear protective gloves to protect hands when working within the sample
compartment and when inserting or removing capillary tubes.
❖
Do not use combustible substances near hot objects.
❖
Do not operate the instrument in the vicinity of flammable liquids or gases.
