Coldair GCV440, Руководство по эксплуатации

Страница: 8 / 20

POWER
Switch the main power button on whichis located on the end of the heater.
After the power is turned on, the computer board emits a
‘click’ and the screen displays the
current room temperature and the set temperature.
Press the On\Off key once to enter the standby state.
HEAT SETTING
Press the
‘Heat Setting’ button to adjust the heat setting from 1000W to 1300W to 2300W & ANTI-
FROST.
In anti-frost: If the heater is in standby and the room temperature is lower than 5
°
C, the heater will
automatically turn on to HIGH heating mode. When the room temperature reaches 9
°
C, the
heating is turned back to standby. This cycle will repeat as required.
TEMPERATURE
The set temperature is displayed every time the appliance is power up. The temperature can be set
when the appliance is in stand-byor heating.
Press the
‘+’ or ‘ - ’ buttons to set the desired room temperature.
The temperature range is 5
°
C-37
°
C.
The appliance can hold the last temperature setting in its memory. This temperature will be shown
at each start-up.
TIMER
Press the timer button, each time the time is increased by 1 hour up to 24 hours. Once the timer is
set, the timer countdown starts after 5 seconds. When the set time has elapsed, the heater will go
back into standby mode.
To cancel the timer, press the timer button until the display read0h 00m.
Operating your Heater
1. Selected heating level display
2. ‘Fan’ symbol
3. ‘Frost protection’ symbol
4. Selected unit of measurement display
5. Fan button
6. Increase temperature
7. Reduce temperature
8. Timer button
9. Running time display
10. Set temperature display
11. Measured temperature display
12. On/Off button
13. Infrared receiver for remote control
14. Wi-Fi button
15. Heat Setting Button
16. Wi-Fi indicator lamp