Cognex VC5, Руководство по оборудованию

Страница: 17 / 49

Connect the Cognex DS1000 Series Sensor
The DS1000 series sensor's Ethernet connector provides a Gigabit Ethernet connection to the DS1000 sensor. The
sensor's 24VDC Power + I/O + Encoder connector provides access to power, encoder and trigger connections. Up to two
DS1000 series displacement sensors can be connected to the vision controller.
WARNING : The DS1000 series sensors are designated as either a Class 2M or Class 3R laser product. These
laser products can be hazardous. Please refer to the DS1000 Series Displacement Sensors Quick Reference
Guide for important instructions on their safe use.
CAUTION :
l
The vision controller only supports connecting DS1000 series sensors with the following Type number:
821-0116-xR. The Type number is located on the label affixed to the DS1000 series sensor.
l
Cognex recommends only cold-plugging the DS1000 series sensor; turn the vision controller power off
when connecting or disconnecting the DS1000 series sensor.
1. Connect the Ethernet cable's M12 connector to the DS1000 series sensor. Connect the cable's RJ-45 connector
to one of the vision controller's GigE ports.
Note :
l
The DS1000 series sensor's accessory Ethernet cable must be used to connect to the vision
controller. For more information, refer to the DS1000 Series Displacement Sensors Quick Reference
Guide .
l
The GigE ports are dedicated to Cognex industrial devices and cannot be used to connect to a
Gigabit Ethernet network or to communicate via industrial Ethernet communication protocols.
2. Connect the Power and I/O cable's M12 connector to the DS1000 series sensor. Connect the cable's DB15
connector to one of the vision controller's SENSOR ports. Tighten the connector screws to secure it to the vision
controller.
17
Installation