10
English
WARNING !
• The use of a thermal magnetic circuit breaker is recommended for each projector. Strict adherance to all regulatory norms
is highly recommended.
• Infinity Wash S should never be supplied mains power via a Dimmer; this is potentially dangerous.
• Prior to powering up the projector, ensure that the model you own correctly matches the mains supply available to you.
• A good earth connection is essential for the correct operation of the Infinity Wash S. Never connect the projector to main
power if the green/yellow earth cable is not correctly connected.
• All cable and plug connection should be carried out by fully qualified and licenced personnel only.
6. control signal connection
Control signal is digital and is transmitted via two pair screened ø0.5mm cable as per international standards for the transmission of
DMX512 data. Connection is serial, utilising XLR3 and XLR5, male and female sockets located on the base of the
Infinity Wash S
,
labeled DMX 512 IN and OUT (see diagram).
Plug/socket connections for XLR3 and XLR5 connectors:
Pin connections conform to the international standard as per the following table:
Pin 1 =GROUND
Pin 2 = DATA -
Pin 3= DATA +
Pin 4= NC
Pin 5= NC
When signal arrives from a DMX 512 console with Cannon XLR5 (5 poles), pin 4 and pin 5 do not have to be connected.
WARNING !
Ensure that all data conductors are isolated from one another and the metal housing of the connector.
Pin n# 1 should never be connected to the device’s power supply.
6.1 Connecting through ArtNet protocol.
ArtNet protocol allows to all the suitable fixtures to behave as a network device such as a normal PC is seen in a network.
Infinity S is ready, as it is, to be included in a ArtNet network without the need for further settings. It just needs to connect the RJ45
connector (found on the panel near DMX connectors) to a generic Ethernet HUB by using a RJ45 patch. The HUB itself, must be
connected to an ArtNet controller. Each Coemar Fixture has its own IP address, so it’s not needed to set it in order to include one fix-
ture in your network. Anyway, Coemar fixtures allow to set custom addressing if exitst particular network needs, In order to customise
the IP address, follow this menu path: MAIN FUNCTION/PROJECTOR CONTROL MODE/ARTNET ONLY (or ARTNET TO DMX)
/CUSTOM IP ADDRESS (see complete menu at chapter 8.3 ).