4) Insert the lamp.
The lamp
is manufactured from quartz glass and should be handled with care; always adhere to the instructions supplied in the
lamp’s packaging. Never touch the glass directly, use the tissue provided in the lamp’s packaging. The GX 9,5 lampholder is symmetri-
cal in construction. DO NOT USE UNDUE FORCE. In case of difficulty, inspect for physical damage and then repeat the installation
procedure.
5) Replace the lamp assembly into its original position and refasten the 2 screws which were previously loosened.
Attention:
we recommend that you realign the lamp in the optical system of the projector to optimise the output.refer to section
13 for a description of this procedure.
The projector is able to operate at 100,115,200/208,230 or 240V;
coemar
preselects (bar-
ring specific requests), an operating voltage of 240 V.
The operating voltage of the projec-
tor is noted on the base of the unit, as shown in the diagram.
Fiera
575 EB
may operate at either 50 or 60 Hz without the need to adjust any settings.
If this preset voltage does not correspond with the conditions in your particular country of operation, follow the instructions in the
appropriate section of this manual, section
17. Altering the operating voltage.
Incorrect frequency and voltage selection will detrimentally affect the operation of the projector and immediately void the warranty.
factory set
main at:
100V
115V
200/208V
230V
240V
50Hz
60Hz
5. Operating voltage and frequency
27
English
