Technical Manual
Issue: A
Revision: 1
Date:21/11/16
Ref:100246
17
Output connector
Separate the two halves of the output connector (it has 7 plugs), by holding the body and unscrewing
the end containing the pins. Feed the cable through the body via the compression nut. Carefully
remove the cable clamp (it is a tension fit). Strip 6mm
(¼’’) of insulation from the end of each core
and insert in the female end of the pin. The pins are all numbered at their base, you may need the
magnifying glass again. Solder each wire into its pin in turn. Screw the body on to the front section
and then tighten the compression gland at the back of the assembly to ensure it is weatherproof. See
Figure 8.
Figure 8: Volt Free Output
Figure 7: Mains Connector
4-20Ma Out
Analogue 0V
N/O Alarm Contact
RB
RA
N/C Alarm Contact
Alarm Common
RS485
