Code Blue CB 1 Series, Руководство администратора

Страница: 14 / 31

Public Address System
Administrator Guide
Code Blue
●
259 Hedcor Street
●
Holland, MI
●
4923 USA
●
800.205.7186
●
www.codeblue.com Rev 12/2018 page 14 of 31 GU-153-G
4.2 CB 5-s with Public Address Installation
4.2.1 Tools Required

Ladder
– to reach the top of the unit.

Security bit - to secure the PAS top to the adapter ring.

3/8
” socket set - to secure the PAS adapter base to the top of the unit.

6mm Allen wrench - to secure the PAS adapter ring to the top of the PAS adapter
base.
4.2.2 Before You Begin
4.2.2.1 Remove 120V AC power from the unit.
4.2.3
Install Adapter Base
4.2.3.1 Remove existing beacon/strobe assembly. Disconnect the red/black and
yellow/yellow wiring harnesses connected to the beacon/strobe mounted on top of the
CB 5-s unit.
4.2.3.2 Place a foam gasket on the unit, then the adapter base on top of the bollard
and tighten the 3/8
” bolts with washers to secure the adapter base to the set screws to
hold in place.
4.2.3.3 Place adapter ring on top of the adapter base and tighten the three Allen set
screws to hold in place (see
Figure 2 on Page 12).
4.2.4 Install 360

PAS Speaker Unit
4.2.4.1 Connect the red/black and yellow/yellow wiring harnesses to the red/black and
yellow/yellow wiring pigtails coming from the beacon/strobe.
4.2.4.2 Connect the 6 pin wiring harness, 7 pin control cable and RJ-11 audio cable to
the ports on the amplifier.
4.2.4.3 Set the PAS speaker unit on the adapter ring, lining up the screw holes at the
bottom of the unit. Secure the speaker unit with the provided security screws.
4.2.4.4 Reapply power to the unit (See Figure 7 on Page 21).