Code Alarm CA100, Руководство пользователя

Страница: 2 / 10

128-6530
2 of 10
Page 2
Your System has many features and available options some of which are
selected at time of installation. Consult your installing dealer for options that
may have been installed and are not listed.
ARMING THE SYSTEM:
1. Turn the engine OFF, exit the vehicle, and close all doors, hood and trunk.
2. Press and release the LOCK button of your key chain transmitter one time.
The parking lights will flash once, the siren will chirp once, and the dash
mounted LED will begin to flash slowly confirming the system is armed. If you
have the optional door lock/unlock circuit installed, the doors will lock.
NOTE: If the siren/horn sounds 3 chirps, then you have left a door, trunk, or
hood lid ajar. Simply close the opened entry point to provide full protection. If
the siren "chirped" 3 times, sometime after arming, the exclusive delayed
dome light learn circuit has been programmed and the system detected a
open entry point after the learned delay expired. Again, closing the hood,
trunk, or doors will correct the problem and you do not need to disarm the
system to make the correction.
ARMING THE SYSTEM:
If the passive arming feature has been selected:
Turn the engine OFF, exit the vehicle, and close all doors, hood and trunk.
The dash mounted LED will begin to flash rapidly indicating that the 30
second passive arming timer has begun. If the LED does not begin to flash
rapidly, then you have left a door, hood, or trunk ajar. Closing this entry point
will allow the arming cycle will begin. If any entry point is opened during the
30 second arming cycle, arming will be suspended. When all entry points are
closed, the arming cycle will begin again.
At the end of the 30 seconds, the parking lights will flash once, the siren will
chirp once, and the dash mounted LED will begin to flash slowly confirming
the system is armed. If the siren did not sound when arming, then the chirps
have been turned off. Refer to the section on "Eliminating the Arm/Disarm
Chirps" shown later in this manual. Passive door locking is a selectable
feature. If you have the optional door lock/unlock circuit installed, the doors
may or may not lock passively depending upon the setup during installation.