Code 3 Z100, Руководство по установке и эксплуатации

Страница: 3 / 8

920-0437-00 Rev. A
Page 3 of 8
1. Using the supplied stainless steel sheet metal screws, begin the assembly by attaching the mounting bracket, #9 for
100 watt driver, to your Light Bar as outlined in your Light Bar User’s Manual. The mounting bracket must be mounted with
two screws.
NOTE: If 100 watt driver is to be mounted in any non-lightbar application (under hood, etc.), attach bracket #9 via the (2)
large 1/4” dia. holes using 1/4” fastener.
2. Next, attach speaker driver #1 to the mounting bracket using the mounting bolts #10 supplied. Take note to install the
speaker driver so that the speaker terminals are horizontally aligned and speaker drain hole is located at the bottom. Drain
hole is located under the 1.0 tag on Atlas drivers.
3. Install the two wire leads by sliding the connectors over the studs protruding from the driver. The studs are marked 1
and 2.
NOTE: When two speakers are connected to the same siren amplifier, the speakers must be connected in parallel and
phased correctly. See Figure 1.
WARNING: Do not attempt to solder wires to studs, as serious damage to driver will result.
4. Install paper washer #6 and rubber washer #7 (2) in speaker tip assembly #8 and set aside.
5. Install steel washer #2, paper washer #3, plastic horn #4 or #5, and second paper washer #3 over the tip of the driver.
See figure 2.
NOTE: The slots/holes in the plastic horn should be on the bottom as are the slots in the mounting bracket.
6. Thread the tip assembly with washers installed onto the end of the driver and tighten by hand. The speaker must be
mounted with two screws through the slots/holes in the plastic horn. The siren speaker assembly is now complete.
Installation & Mounting:
Figure 1
(Two Speaker Hook Up Diagram)