T13795 REV. 1
Page 1 of 2
Specifications:
Input Voltage:
12-36 VDC
Input Current:
2.2 Amps @ 12VDC
Weight:
2.2
lbs.
approx.
Output Power (Lumens):
1300 (Raw)
1100
(Effective)
IMPORTANT!
Read all instructions before installing and using. Installer: This manual must be
delivered to the end user. CODE 3 is not responsible for the misuse of our work light products by un-
authorized personnel.
Do not install and/or operate this safety product unless you have read and understand the safety
information contained in this manual.
1. Proper installation combined with operator training in the installation, use, care and maintenance of vehicle equipment accessories is
essential to ensure the safety of you and those you are trying to protect.
2. Exercise caution when working with live electrical connections.
3. This product must be properly grounded. Inadequate grounding and/or shorting of electrical connections can cause high
current arcing, which can cause personal injury and/or severe vehicle damage, including fire.
4. Proper placement and installation are vital to the performance of this worklamp. Install this product so that output
performance of the system is maximized and the controls are placed within convenient reach of the operator so that s/he can
operate the system without losing eye contact with the work area.
5. It is the responsibility of the vehicle operator to ensure during use that all features of this product work correctly. In use, the
vehicle operator should ensure the projection of the beam is not blocked by vehicle components (i.e., open trunks
or compartment doors), people, vehicles, or other obstructions.
6. The manufacturer assumes no liability for any loss resulting from the use of this device.
WARNING!
Failure to install or use this product according to manufacturer’s recommendations may result in property
damage, serious bodily/personal injury, and/or death to you and those you are seeking to protect!
!
CODE3 INC. CW2450 and CW2451 LED Worklamps feature a fully
adjustable mounting bracket that allows it to be rotated 360º as well
as angled upwards or downwards. A convenient (removable) handle
made of reinforced nylon allows easy repositioning. Other features
include an aluminum heatsink housing, tough polycarbonate lens,
on/off switch and nine 3-watt LEDs that produce a high-intensity
beam. These worklamps are designed to perform in the harshest
of work environments and offer all the benefits of LED technology
including the brightest white light output, a long, maintenance-free
service life and extremely low current consumption.
SAA
NOTE: Black die cast Aluminum housing gets very hot to the touch after operating constantly for several hours.
Installation Instructions:
1. Select a mounting location for the unit on a flat surface. Place the
unit base, flat side down, on the surface.
2. Use the four holes in the base to mark the drill locations for
mounting. It may be necessary to remove the light head from the
base by turning the base handle counter-clockwise until the head
can be removed. For reference, the mounting holes are 50mm x
30mm square, center-to-center.
3. Drill four 5.5mm diameter through holes through the mounting
surface. Align the base with the mounting holes and place the M5
hex head bolts through the base and the holes. Place a washer
on the other end of the bolt and tighten with the M5 nut. Repeat
for the other three bolts.
4. Place the light head back in the base and turn the handle clock
wise until the head is captured. Position the light in the
appropriate direction and fully tighten using the handle.
Installation and Operation Instructions
CW2450 & CW2451 LED WORKLAMP
S
