VOLTAGE FUSE TYPE
100V 8 AMP SLOW BLOW 5 x 20mm
120V 8 AMP SLOW BLOW 5 x 20mm
220V 4 AMP SLOW BLOW 5 x 20mm
240V 4 AMP SLOW BLOW 5 x 20mm
FOR CONTINUED PROTECTION
AGAINST SHOCK OR FIRE:
1. REPLACE FUSE WITH SAME
TYPE AND RATING
2. DO NOT EXPOSE THIS UNIT
TO RAIN OR MOISTURE
UNBRIDGED
UNBALANCED
BALANCED
UNBALANCED
BALANCED
MAIN POWER
OFF
ON
AC LINE FUSE CHART
FUSE AND VOLTAGE SELECTOR
FUSE VALUE -SEE FUSE CHART
VOLTAGE SELECTION-
SEE OPERATION MANUAL
!
NOTE
SEE SERIAL TAG FOR POWER
REQUIREMENTS, REMOVE POWER
CORD BEFORE CHANGING
FUSE OR LINE VOLTAGE
!
120
AC LINE INPUT
~
T E C H N O L O G I E S I N C .
MODEL
SERIAL NUMBER
VOLTAGE REQUIREMENT
MANUFACTURED IN THE USA
HZ
POWER REQUIREMENT
VA
TO PREVENT ELECTRIC SHOCK, DO NOT
REMOVE COVER. NO USER SERVICEABLE
PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
CH 1 OUTPUT
CH 2 OUTPUT
CH 3 OUTPUT
CH 4 OUTPUT
CH 1 INPUTS
CH 2 INPUTS
CH 3 INPUTS
CH 4 INPUTS
UNBRIDGED
C A U T I O N
WA R N I N G
!
BRIDGED-CHANNEL 1
AND CHANNEL 2
BRIDGED-CHANNEL 3
AND CHANNEL 4
BRIDGED-DO NOT USE GROUNDS
BRIDGED-DO NOT USE GROUNDS
DO NOT ALLOW AMPLIFIER OUTPUTS
TO COMMON BETWEEN CHANNELS,
OR CONTACT CHASSIS OR INPUT
GROUNDS, OR TO BE CONNECTED
TO ANY ACTIVE CURRENT SOURCE.
THIS PRODUCT
IS DESIGNED,
ENGINEERED
AND BUILT IN THE UNITED
STATES OF AMERICA.
BRIDGED
INPUT
BRIDGED
INPUT
3
INSTALLATION CONNECTIONS
The first section of the installation instructions for the AMPLIFIER v12 is a diagram of the
default four channel configuration required to bring this amplifier into an operating
mode. These brief steps will allow you to begin operating your system. Make sure during
installation that the main AC power switch on the back of the AMPLIFIER v12 is turned off.
While the diagram may be self explanatory, we strongly recommend that you read the
detailed instructions following this introductory section.
SPEAKER 4
SPEAKER 1
PREAMPLIFIER
PREAMPLIFIER
SPEAKER 3
SPEAKER 2