Cocoon IT315007, Инструкция по эксплуатации

Страница: 10 / 20

10
After Sales Support
1300 663 907
Model Number
IT315007
customercare@winplus.com.au
Installation
2.1 Installing the Control Batteries
1. Use a screwdriver to remove the screw on the back of the remote control, then open the
battery cover.
2. Install 4x AA batteries into the back of the remote control. Please note the polarity positions
indicated.
3. Replace the cover and reinstall the screw.
Note: For best performance, do not mix different types of batteries.
2.2 Charging and Inserting the Voyager Quadcopter Battery
1. Push the on/off switch of the Voyager Quadcopter to off, then open
the battery cover.
2. Pull out the battery wire from the power port and remove battery.
3. Insert the battery power port into the small end of the USB charging
cable.
4. Insert the other end of the USB charging cable into a USB port. The
charging indicator will now turn on.
5. Once the charging indicator has turned off, the battery is fully
charged. A full charge will take approx. 75 minutes.
6. Disconnect the USB cable from the USB port.
7. Disconnect the battery power port from the small end of the USB
charging cable.
8. Reconnect the battery wire to the power port on the Voyager
Quadcopter.
9. Close the battery cover. To ensure it is securely closed, push cover in
until it snap-locks into place
Note: Always charge in a dry and ventilated area.
Always remove the battery from the quadcopter when charging.
Do not charge the battery if the surface is still warm.
Only use the original USB charging cable provided.
Replace the battery if it becomes swollen.
1
2
3
4