Cocoon HE190041, Инструкция по эксплуатации

Страница: 12 / 24

12
After Sales Support
1300 663 907
help@cocoonproducts.com.au
Model Number
HE190041
Waterproof housing
The camera comes supplied with a transparent waterproof housing, which allows you to take video
footage or photos in wet conditions or under water at a depth of up to 30 meters
To use the camera with the waterproof housing, observe the following:
1.
Place the camera in the waterproof housing and close it carefully using the locking clip located at
the top of the case. Make sure the latch lock key is securely in place
2.
Once the camera is securely installed, you can use the power and shutter buttons by pushing the
buttons located on top of the waterproof housing
WARNING: Once the camera is secured in the case, make sure that all seals are in place to prevent
water intrusion.
Before using the camera in wet condition
s
1.
Before sealing the case, ensure the rubber seal of the camera housing is clean — even a single hair
or grain of sand can cause a leak. You can test watertightness by closing the case without inserting
the camera
2.
Submerge the empty case completely in water for about a minute. Remove the case from the water,
dry off its exterior with a towel, then open the case. If the entire interior is dry, the case is safe for
use underwater
3.
After using the camera in saltwater, rinse the outside of the housing with non-saltwater and dry. If
not properly cleaned, corrosion can occur on the hinge and the pin, which can cause failure.
WARNING: Do not use aggressive substances such as acetone to clean the case, as these can cause
permanent damage
4.
To clean the seal, rinse in fresh water and shake dry (drying with a cloth may cause lint to
compromise the seal). Re-install the seal into the grooves in the back door of the housing
Setup & Operation