- 8 -
Do not force the CD door open or
closed at any time.
Keep the CD door closed when the
unit is not in use to prevent dirt and
dust from entering the CD compart-
ment.
Do not put anything other than a CD
in the CD compartment as other ob-
jects may damage the play mecha-
nism.
Never insert more than one CD at a
time.
If a CD is deeply scratched or too
dirty, it may not play (see the Care &
Maintenance section for more infor-
mation).
Never remove a CD from the com-
partment while it is still spinning.
•
•
•
•
•
•
Notes
CD OPERATION
Set the Function switch to the CD position.
Loading a CD
Press the OPEN/CLOSE CD Door button to open
the CD door.
Place the CD in the compartment with the label
side facing up.
Close the CD door. Once the door is closed, the
CD will spin briefly and the total number of tracks
on the CD will be shown on the LED Display.
Playing a CD
Load a CD and press
to start playback. The LED
Display will show the track number being played.
To pause playback, press
. To resume play-
back, press
again.
To select the next track, press
. To fast forward
through a track, press and hold
.
To select the previous track, press
. To reverse
through a track, press and hold
.
To stop playback, press .
Repeat Play Modes
You can set the unit to play a tracks repeatedly. Press REPEAT to cycle through the different Repeat mode op-
tions. To cancel Repeat mode, press REPEAT until the Repeat All/One indicator on the display turns off.
Repeat All (Steady LED): Plays the entire CD repeatedly. If the unit is in Program mode, the unit will play
the entire Program list repeatedly (see the Program Mode section for more information).
Repeat One (Blinking LED): Plays a single track repeatedly.
Program Mode
You can set the unit to play tracks on the CD in a predeter-
mined order. To create a programmed track list:
Press to make sure that the CD has stopped
playing.
Press PROG once. The Program LED indicator will
start blinking and the LED Display will show “0”.
Press FWD or PREV to select a track to program
(the LED display will show the track number) and
then press PROG to add the track to the program
list.
Repeat Step 3 until you have finished adding tracks
to the program list.
Press
to start Program mode playback. To cancel Program mode playback, press twice or open
the CD door.
•
•
•
•
•
•
•
•
•
1.
.
3.
.
.
The program list can store a maxi-
mum of 20 tracks.
The program list will be lost if STOP
is pressed twice, the CD door is
opened, or the unit is turned off.
If
is pressed before PROG dur-
ing track selection, the track will not
be added to the program list. The unit
will start playing the CD from the first
selected track instead.
•
•
•
Notes
