12
MAINTENANCE AND CLEANING
■
Seat Cleaning
·
Make sure that your aerosol canister does not contain
abrasive detergent and disinfector.
·
Exposure to corrosive chemicals or cosmetics (e.g. nail
polish or aftershave lotions) is forbidden as it will damage
surface of the seat.
Tips for maintenance:
clean the seat with water and
detergent mixture or other cleaning products deemed
acceptable for cleaning seat with soft and wet sponge or rag,
then, wipe with soft towel and leave it in the air for natural
drying.
Note:
·
Failure to follow any of these cleaning instructions might
jeopardize your entitlement to quality warranty service.
To ensure best performance of the Product, it is critical to remember following
precautions listed as below while maintaining the Product.
Important! Don’t flush the bidet with water directly.
·
Effectiveness of the cleaning process is subject to several contributors including hardness
and temperature of water used, accurate dosage of detergent, change of cleaning rules and
condition of the cleaned, which may vary or change over time, therefore, Coburg makes no
guarantee to effectiveness of cleaning instructions mentioned above.
■
Surface Cleaning
· Test:
Before applying liquid detergent to clean entire
surface of the bidet, test it at inconspicuous place for a
small area and make sure it would not cause damage to
the lid.
· No soaking in the detergent:
Don’t soak the bidet in the
detergent.
· Avoid using cleaning tools/devices with rough contact
surface,
be sure to use soft and wet sponge or rag instead
of those with rough contact surface such as brush or
scouring pad to clean the surface.
· Wipe-
Wipe the surface immediately after application of
detergent with wet rag to remove any dirt and the
detergent off the surface.
Rag
Abrasive
Corrosive
11
FUNCTIONAL TESTS
·
Cover the seat with plastic membrane to protect it from effect of any water injected out of
bidet during a test.
·
The seat is designed with seating sensing. To activate the seat for this functional test, face
the bidet and put your hand(s) or a piece of wet rag in detectable area on the right side
keeping a distance equivalent to 1/3 of rim length from its front end.
·
Proceed to perform test on different functions according to specification contained in
Section “Control Panel” and “Usage/Operation Method”.
detectable area
