![background image](http://html1.mh-extra.com/html/cobra/mrf55/mrf55_owners-manual_2630575017.webp)
Nothing comes close to a Cobra
®
Mounting And
Powering The Radio
29
Warning Sticker
FCC regulations require that the Warning Sticker
supplied with this radio be applied to a spot where
it is easily seen by the radio operator. Be sure the
location is clean and dry before applying the sticker.
Electrical Power Connection
Your CobraMarine
™
VHF radio is
powered from the vessel’s 13.8-volt
negative ground direct current electrical
system (12 volt nominal). A fused power
connection lead is provided at the back
of the transceiver.
To Connect To A Power Source:
1. Attach the black power wire to a
negative ground.
2. Attach the fused red power wire to
the positive side of the power system.
CAUTION
A reverse polarity connection will damage the radio.
Installation And Start-Up
Power Connection Cables
Red Cable
Positive (+)
Black Cable
Negative (-)
– +
Warning Sticker
Microphone Bracket
To Install The Microphone Bracket:
1. Install the microphone bracket on a
vertical surface near the transceiver
using the supplied stainless steel screws.
Flush Mount
A Flush Mounting kit is included with your CobraMarine
™
VHF radio to allow its installation in almost any flat surface.
To Mount The Transceiver Flush In Almost Any Flat Surface:
1. Use the supplied template to mark and cut an opening
in the flat surface. See page 71 for template.
CAUTION
Before cutting, be sure the area behind the flat
surface is clear of any instruments or wires that
might be damaged in the process.
2. Insert the transceiver into the opening.
3. Attach the mounting brackets to
the sides of the transceiver with
the adjusting screw flanges facing
the back of the flat surface.
4. Tighten the adjusting screws against
the back of the flat surface until the
flange on the front of the transceiver
is tight against the flat surface.
28 English
Installation And Start-Up
Mounting And
Powering The Radio
Use Supplied Template
See page 71
for template.
Insert Transceiver
Adjust Screws
Microphone Bracket
Attach Mounting Brackets