Customer Assistance
Warranty
Introduction
3
3
N
No
otth
hiin
ng
g
Comes Close to a Cobra
®
O
Op
pe
erra
attiio
on
n
2
2
E
En
ng
glliis
sh
h
U
Us
siin
ng
g Y
Yo
ou
urr R
Ra
ad
diio
o
Turning on Your microTALK
®
Radio
••
To turn on your radio:
Rotate the
On/Off Volume
knob clockwise
to turn
on
your radio and adjust the volume.
A series of tones will indicate the radio is
on
.
Your microTALK
®
radio is now in
Standby
mode, ready to receive transmissions. The radio
is always in
Standby
mode, except when the
Talk
,
Call
or
Mode/Lock
buttons are pressed.
Battery Low
••
When battery power is low, the
Battery Low
icon
will blink. Your batteries should be recharged or
replaced if using alkaline batteries.
Auto Battery Save
••
Your microTALK
®
radio has a unique circuit
designed to extend battery life. If there are
no transmissions for 10 seconds, the radio will
automatically switch to
Battery Save
mode and
the
Power Saver
icon will flash in the display.
This will not affect the radio’s ability to receive
incoming transmissions.
O
On
n//O
Offff P
Po
ow
we
err
B
Ba
atttte
erry
y L
Lo
ow
w
B
Ba
atttte
erry
y S
Sa
av
ve
e M
Mo
od
de
e
O
Op
pe
erra
attiio
on
n
The Basics to Get You Started
Your microTALK
®
radio is easy to use.
To get started, simply:
1.
Rotate the
On/Off Volume
knob to turn
on
your radio.
2.
Press the
Channel Up
or
Channel Down
button to select a channel.
Both radios must be tuned to
the same channel/privacy code
to communicate.
3.
Press and hold the
Talk
button while
speaking into the microphone.
4.
When finished talking, release the
Talk
button and listen for a response.
For charging microTALK
®
radio(s) in desktop
charger:
1.
Insert radio(s) into desktop charger as shown.
2.
Insert round connector of 120 volt adapter
into jack on back of charger.
3.
Plug 120 volt adapter into electrical outlet.
If charging light is not
o
on
n
, check position of radio. Radio should be
upright. The charge indicator light will stay
o
on
n
as long as the radio
is in the charging well, even after the batteries are fully charged.
It normally takes about 15 hours to fully recharge batteries.
Batteries will not be damaged if they stay in the charging well
longer than that.
Each port can charge one radio. Uses 120 Volt adapter. Use only
Cobra NiMH batteries, model GA-3ANH with charger model
GA-CC2.
Cobra recommends your radio is turned
o
offff
while being charged.
Insert Radio(s)
