Memory Location Scan
•
Your microTALK
®
radio can automatically scan up to
10 programmed
Memory Locations
.
If there are one or fewer memory locations
programmed in your radio, the scan memory
locations option will not be available. To program
at least two memory locations, see program
memory locations on page 11.
To scan memory locations:
1.
Press the
Mode/Lock
button until the
Scan
icon,
Memory
icon and the memory location
number flash on the display.
2.
Press the
Channel Up
or
Channel Down
button to begin scanning memory locations.
The
Scan
icon and the
Memory
icon will
continue to be displayed when memory
location scan is
on
. Your radio will continue
to scan memory locations and stop if an
incoming transmission is detected. Your
radio will remain on that memory location
for 10 seconds.
While setting memory location scan, if you
do not press any buttons for 15 seconds,
your radio will automatically return to
Standby
mode on the channel/privacy code
displayed before you entered mode functions.
During memory location scan (while receiving an Incoming
transmission), you can choose from the following:
a.
Press and hold the
Talk
button to communicate on that
memory location. Your radio will remain on that memory
location and after 10 seconds of no activity, radio will start
memory location scan again.
b.
Press the
Channel Up
or
Channel Down
button to resume
scanning memory locations.
Customer Assistance
Warranty
Introduction
17
Nothing
Comes Close to a Cobra
®
Operation
16 English
Mode Functions
While setting privacy code scan, if you do not press any buttons
for 15 seconds, your radio will automatically return to
Standby
mode on the channel/privacy code that was displayed before
you entered mode functions.
During privacy code scan (while receiving an incoming
transmission), you can choose from the following:
a.
Press and hold the
Talk
button to communicate on
that channel/privacy code. Your radio will remain on
that channel/privacy code and return to
Standby
mode.
b.
Press the
Channel Up
or
Channel Down
button to
resume scanning privacy codes.
If you press the
Talk
button while scanning, but more than
10 seconds after receiving a transmission, you will transmit
on the channel/privacy code on which you last received a
transmission. This will then return the radio to
Standby
mode.
If you do not press any button within 10 seconds, your
radio will automatically resume scanning privacy codes.
During privacy code scan (while not receiving a transmission),
you can choose from the following:
a.
Press and hold the
Talk
button to communicate on
the channel/privacy code that was displayed before you
entered mode functions or the channel/privacy code on
which, during scanning, you last received a transmission.
This will return the radio to
Standby
mode.
b.
Press the
Mode/Lock
button to proceed to set memory
location scan (see page 17 for further details).
c.
Press the
Enter/Hi•Low
button to return to
Standby
mode on the channel/privacy code that was displayed
before you entered mode functions or the channel/
privacy code on which, during scanning, you last
received a transmission.
Operation
Scanning Locations
Mode/Lock Button
Channel Buttons
