Customer Assistance Warranty
Introduction
21
Operation
20
Operation
Memory Location Scan
•
Your microTALK radio can automatically scan up to
10 programmed
Memory Locations
.
If there are one or fewer memory locations programmed
in your radio, the scan memory locations option will not be
available. To program at least two memory locations, see
program memory locations on page 13.
To scan memory locations:
1.
Press the
Mode
button until the
Scan
icon,
Memory
icon and the memory location number
flash on the display.
2.
Press the
Channel
Up
or
Channel
Down
button to begin scanning memory locations.
The
Scan
icon and the
Memory
icon will continue
to be displayed when memory
location scan is
on
. Your radio will continue
to scan memory locations and stop if an incoming
transmission is detected. Your
radio will remain on that memory location
for 10 seconds.
While setting memory location scan, if you do not press any buttons for
15 seconds, your radio will automatically return to
Standby mode
on
the channel/privacy code displayed before you entered mode functions.
During privacy code scan (while receiving an incoming
transmission), you can choose from the following:
a.
Press and hold the
Talk
button to communicate on that
channel/privacy code. Your radio will remain on
that channel/privacy code and return to
Standby mode.
b.
Press the
Channel
Up
or
Channel
Down
button to resume
scanning privacy codes.
If you press the
Talk
button while scanning, but more than 10 seconds
after receiving a transmission, you will transmit on the channel/privacy
code on which you last received a transmission. This will then return the
radio to
Standby mode.
If you do not press any button within 10 seconds, your radio will
automatically resume scanning privacy codes.
During privacy code scan (while not receiving a transmission),
you can choose from the following:
a.
Press and hold the
Talk
button to communicate on
the channel/privacy code that was displayed before you entered
mode functions or the channel/privacy code on which, during
scanning, you last received a transmission. This will return the
radio to
Standby mode.
b.
Press the
Mode
button to proceed to set memory location scan
(see page 21 for further details).
c.
Press the
Lock/Enter
button to return to
Standby mode
on the
channel/privacy code that was displayed before you entered mode
functions or the channel/privacy code on which, during scanning,
you last received a transmission.
Mode Functions
Mode Button
Channel Buttons
Scanning Locations
Nothing
Comes Close to a Cobra
®
