10 Memory Locations
•
Your microTALK radio has
10 Memory
Locations
for storing
your most frequently used channels and channel/privacy code
combinations. These
Memory Locations
can be selected individually or
can be scanned. (See page 14 for memory location scan.)
To program a memory location:
1.
Press the
MEM/ESC
button.
Memory
icon and
the
Memory Location
show on the display.
2.
Press the
Channel Up
or
Channel Down
button
to select the memory location (0 through 9).
If a location has been programmed before,
its associated channel/privacy code will be
shown on the display.
3.
Press the
MEM/ESC
button to enter a
new memory location or edit an already
programmed memory location.
4.
Press the
Channel Up
or
Channel Down
button
to select the memory location.
5.
Press the
MEM/ESC
button. The channel
numbers will flash on the display.
6.
Press the
Channel Up
or
Channel Down
button
to select a channel (1 through 22).
7.
Press the
MEM/ESC
button. The
CTCSS
icon
and privacy code numbers will flash on the
display.
8.
Choose one of the following:
a.
Press the
Channel Up
or
Channel Down
button to select a CTCSS privacy code (01
through 38) for the channel.
b.
Press the
MEM/ESC
button to switch from
CTCSS to DCS. The DCS icon and privacy code
numbers will flash on the display. The
Channel
Up
or
Channel Down
button can then be used
to select a DCS privacy code (01 through 83)
for the channel.
Operation
Operation
Mode Functions
10
11
Nothing
Comes Close to a Cobra
®
HI / LO
SCAN
MEM/ESC Button
Memory Channel
If “
oF
” flashes in place of the privacy code numbers,
a privacy code is already set in the opposite (CTCSS
or DCS) system. Press the
Channel Up
or
Channel Down
button to cancel the opposite code and select a privacy
code from the active system for the selected channel.
9.
Choose one of the following:
a.
Press the
MEM/ESC
button to enter the channel/privacy code
in the selected memory location. Radio then proceeds to next
memory location, which will blink.
b.
Press and hold the
MEM/ESC
button to save the current state of
the Set Memory Function and return to
Standby mode
.
To recall a stored memory channel location:
1.
Press the
MEM/ESC
button until the
Memory
icon and the memory location number flash on
the display.
2.
Press the
Channel Up
or
Channel Down
button
to select a memory location (0 through 9).
If a location has been programmed before,
its associated channel/privacy code will be
shown on the display.
3.
Press and hold the
MEM/ESC
button to return
to
Standby
mode
on the selected memory
location.
A memory location can be reprogrammed
at any time it is displayed. Press the
MEM/ESC
button to begin.
Memory Channel
Channel Button
HI / LO
SCAN
Channel Button
HI / LO
SCAN
Channel Button
HI / LO
SCAN
Channel Button
HI / LO
SCAN
HI / LO
SCAN
MEM/ESC Button
HI / LO
SCAN
MEM/ESC Button
CXT645_MANL_vB.indd 10-11
9/24/14 3:15 PM
